To Next Page

To Previous Page

Operation Manual - Getting Started

Quidway S5000 Series Ethernet Switches Chapter 4 User Interface Configuration

4-9

 Note:

When a user logs in the switch, the command level that it can access depends on two points. One is the

command level that the user itself can access, the other is the set command level of this user interface. If

the two levels are different, the former will be taken. For example, the command level of VTY 0 user

interface is 1, however, you have the right to access commands of level 3; if you log in from VTY 0 user

interface, you can access commands of level 3 and lower.

IV. Set command priority

The following command is used for setting the priority of a specified command in a

certain view. The command levels include visit, monitoring, configuration, and

management, which are identified with 0 through 3 respectively. An administrator

assigns authorities as per user requirements.

Perform the following configuration in system view.

Table 4-17 Set command priority

Operation Command

Set the command priority in a specified view.

command-privilege level level view view command

Restore the default command level in a specified view. Undo command-privilege view view command

 Note:

Please do not change the command level at will for it may cause inconvenience of maintenance and

operation.

4.2.6 Configure Redirection

I. send command

The following command can be used for sending messages between user interfaces.

Perform the following configuration in user view.

Table 4-18 Configure to send messages between different user interfaces.

Operation Command

Configure to send messages between different user interfaces. send { all | number | type number }

Huawei Quidway S5000 Series User Manual

Other manuals for Huawei Quidway S5000 Series