104 72 30-26 Husqvarna service manual 11
The foot control
Requirements 1
The speed should be continuously controllable from the
lowest r/min to full speed.
Action
Test the foot control on a machine that is known to
operate properly. If it does not work, exchange the
whole control, alternatively the cord device or the
potentiometer.
Requirement 2
The cable should be easily extractable from the cord
device of the foot control and after pulling the cable
slightly it should be rewound on the cord device.
Action
The foot control or the cord device are to be exchanged.
Dismantling (P.49).
The foot control
Requirements
The speed should be continuously controllable from the
lowest r/min to full speed.
Action
Test the foot control on a machine that is known to
operate properly. If it does not work, exchange the
whole control, alternatively the potentiometer.
Dismounting (page 49).
To Next Page
Loading...
Need help?
General
