3012-1066
English - 32
INSTALLATION
3.7 Checking the installation
Check the loop signal by inspecting the indicator lamp on
the charging station.
• Solid green light = good signals.
• Flashing green light = the loop system is turned off
and the robotic lawnmower is in ECO mode. See 6.8
Settings on page 59.
• Flashing blue light = interruption in the boundary loop,
no signal.
• Flashing red light = interruption in the charging
station’s antenna plate. The fault should be rectied
by an authorized dealer.
• Solid blue light = weak signal. This may depend on
the boundary loop being too long or that the wire is
damaged. If the robotic lawnmower still works, this is
not a problem.
• Solid red light = fault in the circuit board in the
charging station. The fault should be rectied by an
authorized dealer.
See 9.3 Indicator lamp in the charging station on page 78 if
the lamp does not indicate a solid or ashing green light.
OM_1157863-26_HQ 310,315,EN_160229.indd 32 2016-02-29 10:51:54
To Next Page
Loading...
Need help?
General
