English - 78
TROUBLESHOOTING
9.3 Indicator lamp in the charging station
For a fully functional installation, the indicator lamp in the charging station must emit a solid green light. If something
else appears, follow the troubleshooting guide below.
There is more troubleshooting help on www.automower.com. If you still need help with troubleshooting, please contact
the local dealer.
Light Cause Action
Solid green light Good signals No action required
Green ashing light
The signals are good and ECO mode
is activated.
No action required. For more information on ECO
mode, see 6.8 Settings on page 59.
Blue ashing light
The boundary loop is not connected
to the charging station
Check that the boundary wire connectors are
tted properly to the charging station. See 3.5
Connecting the boundary wire on page 28.
Break in the boundary loop
Find out where the break is. Replace the
damaged section of the loop with a new loop
wire and splice using an original coupler.
Red ashing light
Interruption in the charging station’s
antenna
Contact the local dealer.
Solid blue light
Weak signal as the boundary wire is
too long. Max length is 800 metres.
No steps have to be taken if the robotic
lawnmower operates as expected.
Shorten the boundary wire by reducing the
working area or replacing islands with barriers
the robotic lawnmower can collide with.
Solid red light
Defective circuit board in the
charging station
Contact the local dealer.
OM_1157863-26_HQ 310,315,EN_160229.indd 78 2016-02-29 10:52:39
To Next Page
Loading...
Need help?
General
