Husqvarna AUTOMOWER 440 Workshop Manual

If ultrasonic has been turned off from Accessories -
Ultrasonic , the product will continuously operate at
reduced speed 46 cm/s / 18 in./s.
• Loop sensitivity : The sensitivity can be set to
Normal or High .
4.4.6 Tools - Calibrate
The Tools - Calibrate menu shows:
• Guide calibration : The guide wire is calibrated
automatically during the first start-up sequence. A
manual calibration may however be necessary, if for
example the charging station installation is changed.
Place the product in the charging station and start
the calibration.
• Tilt sensor calibration : If the product does not
operates as expected in slopes it might help to
calibrate the tilt sensor. Place the product on a
horizontal surface and start the calibration.
• Cutting height calibration : The cutting height
calibration can be enabled and the calibration set to
start the next time the product starts.
4.5 Quick info (Limited Tools menu)
The
Quick info menu is a limited Tools menu .
When the start page or the main menu is displayed:
1. Push and hold down the 0 key for 2 seconds to
access the Quick info menu.
4.5.1 Quick info - Info
The Quick info - Info menu has the same sub-menus as
in Tools , except for the sub-menu Motors and GPS
navigation . Refer to Tools - Info on page 10 .
4.5.2 Quick info - History
The Quick info - History menu has 2 sections: Messages
and Search times .
The History - Messages menu shows:
• Fault messages : The 50 last fault messages
• Info messages : The 50 last information messages.
The History - Search times menu show the same sub-
menus as in Tools - History, total - Search times . Refer
to Tools - History, total - Search times on page 12 .
4.5.3 Quick info - Advanced
The Quick info - Advanced menu shows:
• Automatic passage handling : The guide corridor
width is adjusted automatically. If Auto passage
handling is disabled, the corridor width settings must
be made manually. To disable the Auto passage
handling : Unselect Auto passage handling and push
the OK button.
• Installation shape :
• Open : Applicable in a large open work area with
a small number of obstacles and no passages,
or when the mowing result is uneven in steep
slopes.
• Normal : Applicable in a work area with a
moderate number of obstacles and/or passages.
Applicable for most work areas.
• Complex : Applicable in work areas with many
obstacles and/or passages.
• Calibrate : It has the same submenus as in Tools -
Calibrate . Refer to Tools - Calibrate on page 14 .
4.6 To recover the PIN code
1. In the input mode for PIN code, hold down the 9
button for 3 seconds. A combination of 12 letters
and the serial number of the product will be shown in
the display.
Note: If the product is locked because of an
incorrectly entered PIN code, you must wait before
you try again. The letter combination can be different
if you try again with the same product and with the
same PIN code.
2. Speak to the local sales support and tell them the
letter combination and serial number. They can then
identify the right PIN code.
3. Push the Back button to exit the function.
14 - Special menus 420/430X/430XH/
440/450X/450XH
1191 - 001 -

Husqvarna AUTOMOWER 440 Specifications

General

Brand	Husqvarna
Model	AUTOMOWER 440
Category	Lawn Mower
Language	English