Hydac EDS 3000 User Manual

13
EDS 3000 Operating Manual
PN#02080105 • ELC1603-1752 / 09.16
ELECTRONICS
7. Programming enable
The unit has 2 types of programming enable which must both be set to “ON” to change the
settings. The operating programming enable can be set or removed during operation.
It provides protection from unintentional alteration. Disabling the programming via the main
programming enable means that the settings cannot be changed during operation. This
serves, for example, as a safety function or as protection against unauthorized alterations.
7.1 Altering the operating programming enable
7.2 Altering the main programming enable
Switch off supply voltage or disconnect the unit from the supply voltage.
Note:
If a setting has been changed, “PROG” is displayed briefly when the display is switched over.
The new setting is then saved in the unit.
mode
Press both arrows
simultaneously and
hold for 3 sec.
Display
(release arrow keys)
Change settings with or
SP1 SP2
mode
SP1 SP2
2s3s 3s
Pressure
FrEE = programming possible
Loc = programming locked
mode
Press both arrows
simultaneously and
hold down. Then switch on
supply voltage and
still hold down for 3 sec.
Display
(release arrow keys)
Change setting with or
SP1 SP2
mode
SP1 SP2
2s3s 3s
Pressure
FrEE = programming possible
Loc = programming locked

Hydac EDS 3000 Specifications

General

Brand	Hydac
Model	EDS 3000
Category	Switch
Language	English