Installation and maintenance manual
H.I.B Hydac International Page 8 of 36
Version: G/DV
Date: 11.01.2023
3.0 Machinery Directive 2006/42/EC
The Installation and Maintenance Instructions were revised on 2020-04-29 in accordance with
the Machinery Directive 2006/42/EC.
Equivalent in the Machinery Directive
Avoid accidents by increasing the safety in
the design of the device
Inherent design, potential hazards are discovered
and reduced in the design process. Design
manual with key information on inherent design
available to all designers.
Provision of safety of persons, in particular
through employees and consumers
Installation of electric and mechanical safety
parts
CE marking in accordance with industrial
standard alongside manufacturer’s
information
CE marking alongside name plate
Risk assessment and risk minimisation measures
carried out
Compliance with harmonised industrial
standards
Taken into account in the risk analysis
Table in accordance with number 34 of the Inter-institutional Agreement on Better Lawmaking
Equivalencies between the Machinery Directive 2006/42/EC and implementation measures.
4.0 Warning notes and symbols
4.1 Symbols
WARNING:
This heading is used whenever the ignorance or inaccurate obeying of factory rules,
working rules, laid down work routines, etc. can lead to the death, injury to or an
accident of a person.
ATTENTION:
This heading is used whenever the ignorance or inaccurate obeying of factory rules,
working rules, laid down work routines, etc. can lead to damage to the system.
NOTE:
This heading is used when an exceptional feature should be taken notice of.
MANDATORY:
This heading is used when technical rules or regulations require that a course of
action be observed.
To Next Page
Loading...
General