EasyManuals Logo
Home>Hypertherm>Cutter>Command THC

Hypertherm Command THC User Manual

Hypertherm Command THC
220 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #133 background imageLoading...
Page #133 background image
HT4400 SETUP
3h-8 CommandTHC for X-Y Table Instruction Manual
5
Ohmic contact wire
See Figure 3h-4.
Install the ohmic contact wire through the strain relief of the power supply.
Install appropriate size fork terminal on the wire end and attach the wire to the J5-5 terminal labeled
SHIELD of the plasma interface PC board.
Install the other end of the ohmic contact wire to the IHS tab on the torch retaining cap.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hypertherm Command THC and is the answer not in the manual?

Hypertherm Command THC Specifications

General IconGeneral
BrandHypertherm
ModelCommand THC
CategoryCutter
LanguageEnglish

Related product manuals