Hypertherm Command THC User Manual

MAINTENANCE
5-14 CommandTHC for X-Y Table Instruction Manual
5
Control board status lights during normal power-up
The following LEDs are located on the control board inside the control module. See Figure 5-7.
LED Signal function Status
D9 cycle start input Off
D10 auto height on/off Off
D11 spare input Off
D12 spare input Off
D13 IHS sync input Off
D14 spare input Off
D15 machine cable On
D17 transfer input Off
D18 pilot arc input Off
D19 nozzle contact Off
D20 spare input Off
D21 torch 1 select Off
D22 torch 2 select Off
D23 plasma cable On
D25 machine motion output Off
D26 THC error out Off
(On if there is error)
D27 pilot arc output Off
D28 retract complete On
D29 spare out Off
D30 IHS complete Off
D31 error #1 (Not functional) On
D32 plasma start output Off
D33 hold ignition output Off
D34 pierce complete out Off
D35 spare out Off
D36 spare out Off
D37 high voltage relay active Off
D38 error #2 (Not functional) On
LED Signal function Status
D41 +24v On
D42 –12v On
D43 +12v On
D44 +5v On
D45 response switch 1 Off
(user-definable response)
D46 response switch 2 Off
(user-definable response)
D47 response switch 3 Off
(user-definable response)
D48 crash detect (Future use) Off
D49 home position On momentarily,
then Off
D50 lower limit switch Off
D51 motor current check On
D52 response sw4 Off
D53 drive ID 1 Off
D54 drive ID 2 On
D55 drive ID 4 Off
D56 spare input Off
D57 motor drive installed On
D58 encoder A On or Off
D59 encoder B On or Off

Hypertherm Command THC Specifications

General

Brand	Hypertherm
Model	Command THC
Category	Cutter
Language	English