HPR SETUP
3i-2 CommandTHC for X-Y Table Instruction Manual
11
Install the plasma interface PC board
See Figures 3i-1, 3i-2 and 3i-3
Remove left and right side panels from the power supply.
Install the plasma interface PC board (229145) on the 4 standoffs in the power supply.
Install the machine interface cable (123760) from the control board to the plasma interface board.
Figure 3i-1 Right side panel removal
DANGER
ELECTRIC SHOCK CAN KILL
Turn off all electrical power before removing the power supply cover. Press the power
supply OFF (0) pushbutton switch and set the line disconnect switch to OFF. In the
U.S., use a “lock-out and tag-out” procedure until the service or maintenance is
complete. In other countries, follow appropriate local and national safety procedures.
Note: Only the HPR130 power supply is shown, but the location for installing the plasma interface
board and the location of bundled wires (page 3i-4) are the same in the HPR260 power supply.
To Next Page
Loading...
Need help?
General
