Hypertherm Command THC User Manual

11
HPR SETUP
3i-4 CommandTHC for X-Y Table Instruction Manual
Connect the plasma interface assembly to the THC control module
Install the plasma interface cable (see page 3-22 for part numbers) from the plasma interface PCB in the power
supply to the THC control module.
Install the machine interface cable (see page 3-23 for part numbers) from the THC control module to the CNC.
B
A
Plasma Interface PCB
(inside the power supply)
CNC
THC Control
Module
A
B

Hypertherm Command THC Specifications

General

Brand	Hypertherm
Model	Command THC
Category	Cutter
Language	English