Hypertherm powermax900 User Manual

3-3
SETUP
Operator Manual
HOISTING REQUIREMENTS
If the power supply must be hoisted, read the Warning first and follow this procedure. See Fig. 3-1:
WARNING
The Powermax900 power supply weighs up to 135 pounds (61 kg). Do not hoist the power
supply by one handle; it is not designed to support the weight of the power supply.
Failure to heed this warning could result in personal injury and damage to the power
supply.
1. Use a hoisting strap rated for 4x the full weight.
2. Ensure the power supply cover is secured prior to hoisting.
3. Route strap between both handles as shown in Fig. 3-1.
4. Bring the strap ends together over the center of the power supply and connect them to the
hoisting machine.
5. Hoist and lower the power supply slowly and smoothly - avoid jerking motions.
Figure 3-1 Powermax900 Power Supply Hoisting Setup
Hoisting
Machine
Approved hoisting strap -
keep as vertical as possible
Cover in place

Hypertherm powermax900 Specifications

General

Brand	Hypertherm
Model	powermax900
Category	Welding System
Language	English