3-12
SETUP
Operator Manual
PAC125M ON/OFF Pendant Connection
To connect the on/off pendant lead to the PAC125M machine torch pigtail:
1. Align the pendant lead connector key plug with the connector receptacle key slot on the pigtail
and push in until pins seat.
2. Turn the connector securing ring to the right to tighten.
PAC125M Torch ON/OFF Switch Connection Data
The PAC125M torch lead is supplied with a pigtail so that the on/off pendant may be used. If you want
to use a different on/off switch configuration, note that the wiring configuration to the 3-socket female
receptacle on the pigtail is as follows:
Machine Torch Pigtail
To
Powermax900
power supply
Torch Lead
WARNING
Do not connect cutting machine interface START signal if using the
ON/OFF pendant! (See page 3-13)
On/Off Pendant
Socket A White Wire
Socket B Not Used
Socket C Black Wire
Figure 3-13 ON/OFF Pendant Connection
PAC125M Torch Alignment
Mount the machine torch perpendicular to the workpiece in order to get a vertical cut. Use a square to
align the torch at 0° and 90° as shown in Fig. 3-14.
To Next Page
Loading...
Need help?
General
