Connect for Communication
184 809480 Instruction Manual XPR300
Web interface screen information
If you replace the control PCB, the information stored on the PCB changes. This includes the MAC
address, System ID, passwords, and network information.
System ID – This is the identifier for the plasma power supply. It is the last 4 digits of the
MA
C address. The MAC address is printed on the wireless module on the control PCB.
Operator ID – This is the identifier for the device or
client that has control of the plasma power supply. T
he
fi
rst part of the Operator ID shows the
type of
c
onnection that sent a process, WiFi for wireless,
Uart
422
for serial RS-422, or EtherCAT for EtherCAT.
To change which device has control of the plasma power supply, refer to
Ho
w to change the device that has control on page 192.
Client ID – This is the identifier for a device that communicates with the plasma power
supply. This ID uses the UTC time stamp and is saved in a browser cookie.
If the Client ID and the Operator ID are the same on your device, you are
in
control of the plasma power supply.
Connection – This is the status of the communication between the device and the plasma
power supply
. (Good or Error.)
To Next Page
Loading...
Need help?
General
