Installation
XPR300 Instruction Manual 809480 79
Safety instructions related to installation
Before installation, make sure to read, understand, and follow all of the safety instructions that are in
this manual, the Safety and Compliance Manual (80669C), the Radio Frequency Warning Manual
(80945C), and on to the cutting system.
WARNING
ELECTRIC SHOCK CAN KILL
Disconnect all electric power from the plasma power supply before you move
the plasma power supply or put it into position.
You can be seriously injured or killed if you move the plasma power supply
while it is connected to electric power.
Damage to the plasma power supply also can occur if you move it while it is
connected to electric power.
Refer to the Safety and Compliance Manual (80669C) for more safety
information.
WARNING
ELECTRIC SHOCK CAN KILL
The line-disconnect switch must be in the OFF position before you connect the power
cord to the cutting system. It must REMAIN in the OFF position until all installation steps
are complete.
If the line-disconnect switch is not in the OFF position you can get a serious electric
shock. Electric shock can seriously injure or kill you.
In the United States, use a “lock out/tag out” procedure until installation is complete. In
other countries, follow the appropriate national and local safety procedures.
WARNING
ELECTRIC SHOCK CAN KILL
When the line-disconnect switch is in the ON position, there is line voltage throughout the
cutting system.
Voltages in the cutting system can cause serious electric shock. Electric shock can
seriously injure or kill you.
Use extreme caution if you do diagnosis or maintenance tasks when the line-disconnect
switch is in the ON position.
To Next Page
Loading...
Need help?
General
