RF Data Modem HWC-M100 / HWC-W100 / HWC-W120
23
5. Quick Start for GUI
5.1 Initial Screen after Execution
When you execute the GUI program, the following screen is shown up.
(In case of showing message about the setting of program, please refer to "5.11 Configure
the setting of communication with device"! )
This system consists of Master, AP and EP. As soon as excutuion, you can only see Master
in left window. Therefore, user must request the list of device(AP, EP) by clicking
[Configure Network] or [Request Device List].
There is the following differences between [Configure Network] and [Request Device List].
∎ [Configure Network] : It send commands to Master to gather the list of AP/EP again,
Master begins to gather information and sends the progressing
status and result to GUI.
∎ [Request Device List] : It requests the device list that Master already gathers.
Master sends the device list of AP/EP to GUI.
Tip) After execution, It only show Master. If PC is not connected to Master, you couldn't
see any AP/EP in left window because PC can't receive the device list. In other words,
when PC is directly connected to AP/EP, PC can't receive any device list. In this case,
To Next Page
Loading...
General