FEATURES AND CONTROLS
SANTA FE
1817
HYUNDAI
HOMELINK WIRELESS GARAGE CONTROL SYSTEM
Flashing Flashing
Standard Programming
To train most devices, follow these instructions:
1. Press and hold the two outside buttons on the
Homelink® system until the LED starts to blink, release
buttons.
2. Press and hold the desired Homelink® button and the
transmit button on your rolling code transmitter at the same
time until the Homelink® LED changes from a slow blink to a
rapid blink. (Your Homelink® system is now programmed)
3. Locate the learn code button on your garage door opener.
(These are located under the light cover or on the rear panel
depending on model)
4. Press the learn code button on the garage door opener, a red
LED will start to blink. (You will have 30 seconds to complete
programming)
5. While the LED on the garage door opener is blinking, return to
the vehicle and press the pre-programmed Homelink® button
4 times. (Or until the garage door operates).
BLUETOOTH PHONE PAIRING
With Display Audio
NOTE: Vehicle must be parked to complete
the pairing process.
1. Press the PHONE button in the head unit or
button in the steering wheel remote
controller.
2. Press <YES> to search for Bluetooth phones.
3. Pair your car after your mobile phone detects
the Bluetooth device.
4. Enter the passkey or accept the
authorization
popup. (The default passkey is 0000.)
5. Connect Bluetooth.
With Navigation
RADIO
MEDIA
SETUP
PHONE
TUNE
FILE
ENTER
VOL
POWER
PUSH
SEEK
TRACK
HOME
RADIO
MEDIA
MAP
NAV
SETUP
TUNE
FILE
ENTER
VOL
POWER
PUSH
SEEK
TRACK
1. Press the PHONE button.
2. Search for car name on the Bluetooth list
from your mobile phone and pair device.
3. Input the passkey. (Initial passkey is 0000)
4. Bluetooth becomes connected.
MULTIMEDIA
To Next Page
Loading...
Need help?
General
