Line cords
A 4.3 m (14 ft) country-specific line cord that you use to connect your Rack PDU to
a properly wired, grounded, and dedicated power source comes with the Rack
PDU. The following table contains a list of line cords that you can use with the Rack
PDU:
Power Source
Line cord
rating Plug type
Line cord
part #
100–127 V ac, 20
A
127 V ac, 18 A IEC 320-C19 to NEMA L5-20P 12J5117
200–240 V ac, 20
A
250 V ac, 18 A IEC 320-C19 to NEMA L6-20P 14F1553
220–240 V ac, 16
A
250 V ac, 16 A IEC 320-C19 to CEE7-VII 14F1554
220–240 V ac, 16
A
250 V ac, 16 A IEC 320-C19 to IEC 309-2P + Gnd 36L8823
220–240 V ac, 16
A
250 V ac, 16 A IEC 320-C19 to SII 32 14F1561
220–240 V ac, 16
A
250 V ac, 16 A IEC 320-C19 to CEI 23-16 14F1560
220–240 V ac, 16
A
250 V ac, 16 A IEC 320-C19 to SABS 164 14F1557
220–240 V ac, 13
A
250 V ac, 13 A IEC 320-C19 to BS 1363/A 12J5988
220–240 V ac, 15
A
250 V ac, 15 A IEC 320-C19 to AS/NZ 3112 14F1559
220–240 V ac, 15
A
250 V ac, 15 A IEC 320-C19 to GB 2099.1 01K9852
220–240 V ac, 15
A
250 V ac, 15 A IEC 320-C19 to IRAM 2063 36L8885
NetBAY front-end Power Distribution Unit introduction
The IBM NetBAY Single-phase and Three-phase Front-end Power Distribution Units
are part of the Rack Modular Power Distribution Unit (M/PDU) family and enable
you to connect a single-phase or three-phase dedicated power source to three
different single-phase PDUs in the M/PDU family. The Rack PDU has one power
source inlet and three IEC standard power outlets.
Notes:
1. You will have some unused parts depending upon how you install the Rack
PDU.
2. You can install other M/PDU family devices next to your Rack PDU using
mounting hardware from both devices.
Installing Optional Devices 145
To Next Page
Loading...
Need help?
General