Connections
M
O
N
O
V
G
A
1
K
B
O
V
G
A
2
V
G
A
3
V
G
A
4
V
G
A
5
V
G
A
7
V
G
A
6
V
G
A
8
M
O
U
K
1
M
1
K
2
M
2
K
3
M
3
K
4
M
4
K
5
M
5
K
6
M
6
K
7
M
7
K
8
M
8
Server
Monitor
Connections
AC Power
Input
Server Selector
Unit On-Off
Switch
Server Rack
Mouse
Connection
Server Rack
Keyboard
Connection
Server Rack
Monitor
Connection
Server Keyboard
and Mouse
Connections
Power distribution unit
Note: For information and installation instructions for the IBM NetBAY Rack Power
Distribution Units, see “Installing Optional Devices” on page 101″.
Note: To remove the power distribution unit, you might need to remove the right
side cabinet panel, the server installed in sliding tray 2 (in the primary IBM
PC Server Rack), or sliding tray 5 (in the IBM PC Server Expansion Rack).
To remove the power distribution unit:
1. Power-off the rack.
2. Disconnect all power plugs from the power distribution unit.
3. Using a Phillips screwdriver, remove the four screws from the front of the power
distribution unit.
Note: These screws are held in place by nuts and washers. Hold the nut while
you are unscrewing the screw to prevent the nut and washer from falling
into the bottom of the cabinet.
4. Remove the power distribution unit from the cabinet.
Type 9306 Models 4QS, 4QX, 9QS, 9QX, 9TS, 9TX 43
To Next Page
Loading...
Need help?
General