Table 17. RackSwitch G8052, Model 1455-48E replaceable parts (continued)
Description Tier 1 CRU part number
25 m blue Ethernet 40K8970
0.5 m IBM passive DAC SFP+ 00D6289
1 m IBM passive DAC SFP+ 90Y9426
3 m IBM passive DAC SFP+ 90Y9429
5 m IBM passive DAC SFP+ 00D6150
7 m IBM passive DAC SFP+ 49Y7930
8.5 m IBM passive DAC SFP+ 90Y9435
1 m IBM active DAC SFP+ 46K6182
3 m IBM active DAC SFP+ 46K6183
5 m IBM active DAC SFP+ 46K6184
1 m IBM QSFP+ DAC (breakout) 49Y7930
3 m IBM QSFP+ DAC (breakout) 49Y7931
5 m IBM QSFP+ DAC (breakout) 49Y7932
1 m IBM QSFP-to-QSFP 49Y7934
3 m IBM QSFP-to-QSFP 49Y7935
5 m IBM QSFP+ to QSFP+ 00D5809
7 m IBM QSFP+ to QSFP+ 00D5812
1.0 m InfiniBand 74Y6074
3.0 m InfiniBand 74Y6075
Rail kits
2-post rack mounting 90Y3532
IBM System Networking adjustable 19"
4-post rail
00D6119
1U, air duct, 483 mm 00D6120
For your safety, a power cord with a ground attachment plug is available to order
for use with this product. To avoid electrical shock, always use the power cord and
plug with a properly grounded outlet.
Power cords for this product that are used in the United States and Canada are
listed by Underwriter's Laboratories (UL) and certified by the Canadian Standards
Association (CSA).
For units intended to be operated at 115 volts: Use a UL-listed and CSA-certified
cord set consisting of a minimum of 18 AWG, Type SVT or SJT, three-conductor
cord, a maximum of 15 feet in length and a parallel blade, grounding-type
attachment plug rated 15 amperes, 125 volts.
For units intended to be operated at 230 volts (U.S.): Use a UL-listed and
CSA-certified cord consisting of a minimum of 18 AWG, Type SVT or SJT,
three-conductor cord, a maximum of 15 feet in length and a tandem blade,
grounding-type attachment plug rated 15 amperes, 250 volts.
Chapter 6. Replaceable switch parts 57
To Next Page
Loading...
Need help?
General