Failing Item Description Document Description
PROC0 System processor card Problem Analysis; Symbolic FRU Isolation
PROC1 System processor card Problem Analysis; Symbolic FRU Isolation
PROC2 System processor card Problem Analysis; Symbolic FRU Isolation
PROC3 System processor card Problem Analysis; Symbolic FRU Isolation
SPCNCRD SPCN card Problem Analysis; Symbolic FRU Isolation
STORIOA Storage I/O Adapter Problem Analysis; Symbolic FRU Isolation
SVCPROC Service Processor Card Problem Analysis; Symbolic FRU Isolation
SYSUNIT System unit Problem Analysis; Symbolic FRU Isolation
TOD Control Panel Battery Problem Analysis; Symbolic FRU Isolation
TWRCARD Card enclosure or backplane Problem Analysis; Symbolic FRU Isolation
UCSPIP Service Processor Problem Isolation Procedure
UCSUSER Option not valid at this time Service Functions; Working with Storage Dumps
VPDCONC The system vital product data has failed Problem Analysis; Symbolic FRU Isolation
(A6xx) LIC Reference Codes
Use the “(B6xx) Licensed Internal Code (LIC) Reference Codes” on page 262.
(A9xx, B9xx) Reference Codes
This section informs service representatives that all A9xx and B9xxx SRCs and their
associated unit reference codes give information about the user (customer)
program.
1. The service representative should have the user see “Problem Handling Tables
and Procedures” in the Information Center at
http://www.ibm.com/eserver/iseries/infocenter for the descriptions and
actions indicated by these reference codes. For additional help, the user should
contact their next level of support.
Note: A brief description of some of the C9xx codes can be found in the iSeries
Service Functions information (see “IPL Status SRC Sequence” under
“Initial Program Load Information”).
A complete description and definition of these codes are found in the iSeries
OS/400 Diagnostic Aids information under “Unit Reference Codes”. This
information is used by the support representatives.
2. If a Licensed Internal Code error is suspected and the recovery action
recommends an IPL, then take a main storage dump to save the error
conditions (see “Working with Storage Dumps” in the iSeries Service Functions
information) before the customer does an IPL. Support may need the
information saved in this dump.
3. Have the customer continue with the recommended recovery action.
(B003) Asynchronous Communications Reference Codes
The Asynchronous Communications detected a failure.
A1xx, B1xx
System Reference Codes 201
To Next Page
Loading...
Need help?
General