To Next Page

To Previous Page

1. Create an FMR tape (see “Function Code 3: Create FMR tape” on page 23). A

single FMR tape can be used to update multiple drives if the drives are the

same drive type (e.g. LTO Gen4) and host interface (e.g. SCSI, SAS, fibre

channel).

2. Update the drive firmware (see “Function Code 2: Update drive firmware from

FMR tape” on page 22).

After updating the drive firmware, the FMR tape can be used as a data cartridge

by using the "Unmake FMR Tape" function (see “Function Code 8: Unmake FMR

tape” on page 27).

36 LTO Ultrium 4 Half High Tape Drive

Questions and Answers:

Need help?

Do you have a question about the IBM LTO Ultrium 4 and is the answer not in the manual?

IBM LTO Ultrium 4 Specifications

General