EasyManuals Logo

IBM Storwize V7000 Unified Quick Installation Guide

IBM Storwize V7000 Unified
108 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background image
Chapter 1. Before you begin the installation
This topic contains a set of instructions to help you plan your installation.
The Quick Installation Guide contains a set of instructions to help you unpack and
install your system. The guide is divided into three chapters. The steps in the first
chapter involve verifying your order, becoming familiar with the hardware
component terminology, and ensuring that you have met the environmental
requirements. The steps in the second chapter involve installing the hardware and
attaching the data cables and power cords. The final chapter helps you configure
the file modules and control enclosures. It ends with enabling the Tivoli Assist
On-site support program.
Occasionally you are referred to topics in the Storwize V7000 Unified Information
Center. A copy of the Storwize V7000 Unified Information Center is on the CD that
is included in your shipping order.
Important information:
1. You must first work through the planning information regarding your physical
environment and logical network in the Storwize V7000 Unified Information
Center.
2. Ensure that you have available any cables that you are supplying.
3. Pay attention to any flyers that were shipped with your shipping order.
4. Check the IBM support home page http://www.ibm.com/storage/support/
storwize/v7000/unified for any information revenant to planning, installing
and configuring a Storwize V7000 Unified system.
5. The Initial setup e-Learning module is available on the IBM Storwize V7000
Unified Information Center. Refer to Initial set up, located under Learning and
tutorials.
6. You should use the management GUI to update to the latest Storwize V7000
Unified software immediately after completing the initial configuration.
7. Event notifications and call homes from the Storwize V7000 storage enclosures
are done by e-mail. The IP address of an e-mail server which can access the
internet is required. Call home from a file module is done by electronic
customer care (ecc) using ssh. This requires a proxy server to access the internet
or your firewall must be made to allow each file module service IP address to
ssh to the IBM call home IP addresses (*.ibm.com) on the internet.
IBM Storwize V7000 Unified Information Center
The most current information for Storwize V7000 Unified is available in the IBM
Storwize V7000 Unified Information Center at publib.boulder.ibm.com/infocenter/
storwize/unified_ic/index.jsp. If you are unable to access the internet, there is a
copy of the information center on the software CD that was shipped with the
product, it contains the environmental notices, the publication PDFs, and the
information center content. Insert the CD into a Windows based system, it
automatically starts.
Step 1. Reviewing your packing slip
Check that your packing slip matches the ship contents.
© Copyright IBM Corp. 2011, 2012 1

Table of Contents

Other manuals for IBM Storwize V7000 Unified

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM Storwize V7000 Unified and is the answer not in the manual?

IBM Storwize V7000 Unified Specifications

General IconGeneral
ModelIBM Storwize V7000 Unified
Storage TypeUnified Storage
RAID LevelsRAID 0, 1, 5, 6, 10
Form Factor2U
Drive Types SupportedSAS, SSD
Maximum Drives504
Network ProtocolsiSCSI, FC, FCoE
Drive Bays24 per enclosure
Host Interface8 Gb FC, 1 Gb/10 Gb iSCSI
File ProtocolsNFS, CIFS
Block ProtocolsiSCSI, Fibre Channel
TypeUnified Storage
Maximum Host Ports16
Operating System SupportVMware, Microsoft Windows, Linux, AIX
Data ServicesThin provisioning, replication
Power SupplyRedundant power supplies
Host Interfaces8 Gbps Fibre Channel, 10 Gbps iSCSI, 1 Gbps iSCSI

Related product manuals