Tables
1. Storwize V7000 Unified library .....xviii
2. Other IBM publications ........xx
3. IBM documentation and related websites xx
4. The following IP address information is
required before initializing your system. Fill in
all the information needed in the Value
column before proceeding with this
installation. ............14
5. This table can be used for recording the
information needed for the initial
configuration wizard in the management GUI.
The table entries serve as a guide only. Enter
the Value column with your system
information. ............17
6. Information that the system will provide to
IBM Remote Technical Support ......18
7. All the information in this table is required. 19
8. CIDR subnet mask information ......19
9. Authentication method information. Refer to
the notes above ...........22
10. Active Directory Configuration Information 22
11. LDAP CONFIGURATION INFORMATION 24
12. NIS configuration information ......25
13. Use this table to identify the file module,
control enclosure, and expansion unit port
locations. Follow the links to identify detailed
port locations.............43
14. How to connect SAS cables to expansion units. 44
15. Ethernet connections available with the control
enclosure .............49
16. Ethernet connections available with the file
modules .............50
17. LED status front of control enclosure or
expansion enclosure. Refers to item [1] in the
figures above. ............57
18. LED status rear of expansion enclosure. 58
19. LED status when control enclosure is powered
on................59
20. Create two files and enter one line each,
adjusted to the values fitting to your
environment. ............64
© Copyright IBM Corp. 2011, 2012 vii
To Next Page
Loading...
Need help?
General