Chapter 9. Post configuration of the Storwize V7000 Unified
system
Perform these tasks after the initial configuration of the Storwize V7000 Unified
system.
About this task
Management GUI and CLI:
You should stop using the Storwize V7000 management GUI and CLI. Everything
you need to do should now be covered by the Storwize V7000 Unified
management GUI and CLI which are accessed through the management IP address
of the system.
What was known as the management IP address of the Storwize V7000 is usually
refereed to as the system IP address of the storage system now that it is part of a
Storwize V7000 Unified system.
Information Center:
You should stop using the Information Center and any hard copy Guides for the
Storwize V7000 system. From now on use the Information Center for the Storwize
V7000 Unified system.
http://pic.dhe.ibm.com/infocenter/storwize/unified_ic/index.jsp
The Information Center includes some helpful e-learning modules to help you
become familiar with the Storwize V7000 Unified system.
System health check:
The management GUI will have checked the system health before it completed.
There is also a health indicator in the bottom right of each panel of the
management GUI.
Root access:
It is best practice to change the root password for the file modules and store it in a
place that only those with a need to know will be able to access it. You or IBM
support may need this root password for use in some problem determination and
recovery procedures.
Administrative users:
If you had created any user IDs on the V7000 for administration of the system then
you may now create similar administrative User IDs on the Storwize V7000
Unified management GUI ( management GUI ).
© Copyright IBM Corp. 2012, 2014 115
To Next Page
Loading...
Need help?
General