__ – Two sets of two 10-32 screws per chassis
__ – Cable management support arm
__ – Cable management arm stop bracket
__ – Cable management arm assembly
Note: The rail kit for the file module differs from the rail kit for the control
enclosure.
__ v Two power cords
__ v Small form-factor pluggable (SFP) transceivers that are preinstalled in the file
module.
__ v Any additional fibre optic cables that you ordered.
One documentation pack:
__ v Read first flyer
__ v Read first information flyer
__ v Quality hotline flyer
__ v Environmental notices CD
__ v Environmental flyers
__ v Safety notices
__ v Limited warranty information
__ v License information
__ v License Function authorization document
__ v International Program License Agreement
__ v IBM Storwize V7000 Unified Problem Determination Guide
__ v IBM Storwize V7000 Unified Publications DVD
__ v IBM Storwize V7000 Unified Software Recovery DVD. One DVD is shipped
per file module
__ v USB flash drive for initialization of Storwize V7000 Unified
Identifying the hardware components
The following graphics and descriptions identify the various hardware components
and port locations for the control enclosure in the existing system, and file
modules to be added.
Control enclosure
Each enclosure has drives that are located on the front. Figure 8 on page 44 and
Figure 9 on page 44 show the front of an enclosure that has space for up to 12 or
24 drives 2, depending on the model, and a left end cap 1 and a right end cap
3.
Chapter 3. Before you begin adding file modules 43
To Next Page
Loading...
Need help?
General