9. Press hard disk drive cage in until the release latches click into place.
Cage release latches
10. Install the simple-swap hard disk drives that you removed from the hard disk
drive cage (see “Installing a simple-swap hard disk drive” on page 196).
11. Install the air duct.
12. Install the side cover (see “Installing the side cover” on page 167).
13. Stand the server back up in its vertical position.
14. Install bezel (see “Installing the bezel” on page 171).
15. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Removing the hot-swap hard disk drive backplane
This procedure applies only to the 5U server model with hot-swap power supplies
(Model name: 2582-F4x).
To remove the hot-swap backplane on the 5U server model with hot-swap power
supplies (Model name: 2582-F4x), complete the following steps.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 163.
2. Turn off the server and all attached devices; then, disconnect all power cords
and external cables.
3. Unlock and remove the side cover (see “Removing the side cover” on page
166).
4. Remove the lower bezel (see “Removing the lower bezel” on page 171).
5. Remove the hot-swap SAS/SATA hard disk drives installed in the hard disk
drive cage (see “Removing a hot-swap hard disk drive” on page 198).
6. Carefully turn the server on its side so that it is lying flat, with the system
board facing up.
Attention: Do not allow the server to fall over.
222 IBM System x3100 M4 Type 2582: Problem Determination and Service Guide
To Next Page
Loading...
Need help?
General