Note: Carefully pull the cable out from the opening. Do not allow the LED to
disconnect from the front-panel assembly.
9. If you are instructed to return the front-panel assembly, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
To remove the front-panel assembly on the 5U server model with hot-swap power
supplies (Model name: 2582-F4x), complete the following steps. For 4U server
models with non-hot-swap power supplies, please see the above sub-section.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 163.
2. Turn off the server and all attached devices; then, disconnect all power cords
and external cables.
3. Unlock and remove the side cover (see “Removing the side cover” on page
166).
4. Remove the lower bezel (see “Removing the lower bezel” on page 171).
5. Remove the upper bezel (see “Removing the upper bezel” on page 174).
6. Slide the drives in bay 1 and bay 2 forward slightly (see “Removing a DVD
drive” on page 184 and “Removing a tape drive” on page 188 for more
information). It is not necessary to remove these drives.
7. Carefully turn the server on its side so that it is lying flat, with the system
board facing up.
Attention: Do not allow the server to fall over.
8. Remove the hot-swap power supplies and the hot-swap power-supply cage
(see “Removing the hot-swap power supply” on page 243) and “Removing the
hot-swap power supply cage” on page 247).
Chapter 5. Removing and replacing server components 227
To Next Page
Loading...
Need help?
General