Icom IC-7200 Service Manual

4 - 3
ADJUSTMENT
DISPLAYED
ITEM
OPERATION VALUE
IDLING
CURRENT
1 [ID SET] • Push [SET] key. –
2
[ID +0.8A]
• Measure the driving currrent, and note it as the initial value. (Note the driving
current value)
3
[ID1V]
• Push [SET] key. (Beep "Pi!" sounds)
(After 2.5 sec., another beep "Pipi!" sounds)
–
4
[ID2V]
1) Adjust the idling current using [DIAL].
2) Push [SET] key.
+0.8 A more than
initial value
5
[ID3V]
• Push [SET] key. (Beep "Pi!" sounds)
(After 2.5 sec., another beep "Pipi!" sounds)
–
6
[ID4V]
• Push [SET] key. (Beep "Pi!" sounds)
(After 2.5 sec., another beep "Pipi!" sounds)
–
7
[ID5V]
• Push [SET] key. (Beep "Pi!" sounds)
(After 2.5 sec., another beep "Pipi!" sounds)
–
4-2 ADJUSTMENT
• TRANSMITTER ADJUSTMENT
DC 13.8V ACC
KEY SEND ALC ANT
REMOTE EXT SP
GNDTUNER
AMMETER
(0.1–30 A)
Fuses
30 A
DC power supply
(13.8 V/30 A)
⊕
−
Black
Red⊕
Red⊕
−
Black
−
−
Supplied DC cable
50 ohms coaxial cable
DUMMY LOAD
(50 Ω/120 W)
2-conductor 3.5(d) mm plug
(connect)
• SHORT PLUG

Icom IC-7200 Specifications

Ports & interfaces

connector type	USB B type
interface	USB 2.0/1.1
serial speed	300/1200/4800/9600/19200 bps

Power

power supply	Self power

Audio

received audio output number of data bit	16-bit
received audio output sampling rate	8/11.025/16/22.05/32/44.1/48 kHz
modulation input number of data bit	16-bit
modulation input sampling rate	32/44.1/48 kHz