n “TAG” channel setting
Memory channels can be specified to be skipped for the
memory channel scan. The “TAG” channel function is only
available during scan operation.
For IC-A15
q Push [MR] to select memory mode.
• Select the desired BANK if desired.
w Select the desired memory channel to be a “TAG” chan-
nel.
• Select the desired BANK if desired.
e Push [FUNC]
,
then push [TAG](9) to set a “TAG.”
• “TAG” appears.
• Non-“TAG” channels are skipped during scan.
r To cancel the “TAG” setting, repeat above steps.
For IC-A15S
q Push [MR] to select memory mode.
w Select the desired memory channel to be a “TAG” chan-
nel.
e Push and hold [LIGHT] for 2 sec. to set a “TAG.”
r To cancel the “TAG” setting, repeat the above steps.
n Memory scan
NOTE: Program 2 or more memory channels with “TAG”
setting to start memory scan.
q Push [MR] to select memory mode.
• For IC-A15, select the desired BANK if desired. (p. 12)
w Push [SQLY]/[SQLZ] to set the squelch level to the
point where noise is just muted.
For IC-A15
e Push [FUNC], then push [SCAN](2) to start the scan.
• When a signal is received, the scan pauses until it disappears.
• To change the scanning direction, push [Y]/[Z].
For IC-A15S
e Push and hold [Y]/[Z] for 1 sec. to start the scan.
• When a signal is received, the scan pauses until it disappears.
• To change the scanning direction, push [Y]/[Z].
19
5
SCAN OPERATION
To Next Page
Loading...
Need help?
General
