D Memory channel scan
Normal scan
Repeatedly scans tagged memory channels belonging
to the same group.*
*Scans all memory channels, depending on the presetting.
L You can tag or untag a memory channel on the “TAG Set”
screen.
([MENU] > Manage Memory > Edit Memory >
(Select a group) > (Select a channel) > TAG Set)
(p. 8-6)
Priority scan
While scanning, Priority watch checks for a signal on
the selected Priority channel.
L You can select a priority channel on the “Priority CH”
screen.
([MENU] > Radio Settings > Priority CH) (p. 9-2)
The transceiver have any one type of scan function as
shown below, depending on the presettings.
Ask your dealer for details.
D VFO scan
Repeatedly scans all frequencies over the entire band.
IC-A25N/IC-A25NE
The transceiver scans the COM and NAV bands.
L May not scans the NAV band, depending on the
presettings. Ask your dealer for details.
IC-A25C/IC-A25CE
The transceiver scans only the COM band.
7
SCAN OPERATION
7-2
Scan types
Mch 1
Mch 2
Mch 3
Mch 200
Untagged
channel
Priority
channel
Mch 1
Mch 2
Mch 3
Mch 200
Untagged
channel
118.000
MHz
Jump
136.9917 MHz
108.000
MHz
Scan
NAV band COM band
Using the Scan function
1. Push [F], and then push [SCAN] to start a scan.
• “SCANNING” blinks while scanning.
L Rotate [DIAL] to change the scanning direction.
L When receiving a signal, the scan stops and “RX” is
displayed.
L Rotate [DIAL] to resume the scan, even if a signal is
received.
L When a signal is disappeared, the transceiver
automatically resumes the scan in 3 seconds.
2. Push [CLR] to cancel the scan.
Scan
Jump
118.000
MHz
108.000
MHz
136.9917 MHz
To Next Page
Loading...
Need help?
General
Weight and Dimensions
