3 DEALER-PROGRAMMABLE FUNCTIONS
• Receive • Transmit
¢ MONITOR FUNCTION
This function allows you to open the transceiver's squelch
manually to
check
whether
a channel is busy
or
not. The
transceiver has 2 squelch systems as follows.
¢ OUTPUT POWER SELECTION
Push [P] momentarily to change the power output.
• "LOW" appears when one
of
the low output powers is selected.
• Push and hold [P) for 2 sec. to return to the original
power
output.
•
On
some channels, high power cannot be selected.
..
Push [Pl to turn off the tone squelch for reception of all sig-
nals (even those not directed to you specifically).
..
Push and hold [P] for 2 sec. or more to monitor all signals
(or noise) regardless of the active squelch system.
• After releasing [P), tone squelch is activated.
Tone squelch: The squelch mutes all signals except
V those directed to you. Therefore, you
~
Z
should
check
a channel's condition
c:::l
only signals (busy
or
not) with the monitor function
containing before transmitting.
the proper
tone are
received
Manual
transmission:
Push digit keys while pushing [PTT].
• Pushing
[PIT]
may
not be necessary depending on programming.
n T
"'1'-
Lf
I 1
f"
-·-
• See Channel Selection,
p.
3.
o DTMF TRANSMISSION
This allows you to send pre-programmed DTMF
codes
to
control a repeater, open another transceiver's squelch, etc.
Automatic pre-programmed transmission:
..
KEYPAD ENTRY TYPE*:
keypad entry
Push
[Pl, then a digit key
(1
to 8).
..
ROTARY SEL TYPE*:
channel selector
Set the channel selector
(1
to 8), then push [P].
The squelch mutes audio only when
no carrier is present.
You
can receive
(or monitor) any signals on a channel.
Noise squelch:
~/
:-'---.
c::5
all signals
are
received
7
To Next Page
Loading...
Need help?
General
