Icom IC-F30 User Manual

OPTIONAL SmarTrunk IITM OPERATION
11
• SmarTrunk IITM and
conventional modes
When the optional UT .. 105 is installed, you can communicate
using conventional channels or SmarTrunk IITM channels.
Select a channel bank for SmarTrunk
IITM before trunking op ..
eration.
Rotate the channel selector or push [P] one or more times to
select a channel
bank for conventional channels or
SmarTrunk
IITM channels.
• Scanning starts when a channel bank for SmarTrunk II™ is se-
lected.
• Contact your dealer for channel bank details.
• SmarTrunk IITM operation
These features are enabled by a dealer or system operator
and may not be available
in your system. Contact your dealer
for details.
<> Placing a telephone call
Enter the phone number followed by [1], [*].
• A high-pitched beep indicates that the number is accepted.
• When the called party answers, push [PTT] to talk, and release it to
listen.
<> Calling another local system subscriber
Enter the subscriber number followed by [3], [*].
• A high-pitched beep indicates that the number is accepted.
• You hear ringing, then two short beeps when the subscriber an-
swers.
• If the other subscriber is on another call or out of range, you hear a
fast busy signal and the call terminates automatically.
<> Receiving a call
When you hear ringing, push [*l to answer.
• For a group call, you hear a short ring followed by two short beeps.
You do not have to answer a group call to hear it over the air.
<> Terminating a call
After completing a call, push [#] to disconnect (hang up).
Important: If one person in the conversation terminates a
call, all participants will be cut off.
<> Last number redial
Push [*1, [*1 to automatically redial the last number called.
• A high-pitched beep indicates that the number is accepted.
<> Memory speed-dialing
To automatically dial a commonly used number from memory:
Push [P] followed by the memory location (0-9).

Icom IC-F30 Specifications

General

Brand	Icom
Model	IC-F30
Category	Transceiver
Language	English