Icom IC-H2 Service Manual

6 - 5 UNIT BOTTOM ASSEMBLY
(BOTTOM VIEW)
1.
2.
t;:::.========:=:=:=:=::::;:!\4---FRONT PANEL
.....---.----SLIDING GUIDE (A)
@ ~~~~~-'--+--1----CONT ACT HOLDER
©t>
@ ~~~g)J
1--------2====nr=r--i----CONT ACT SPRING
~==================;r--- REAR PANEL
(HOW TO REPLACE CONTACT SPRING)
Remove the sliding guide by removing the four screws as shown.
Remove
the contact spring by removing the two screws as shown.
3.
Set the new contact spring so that the split of the spring is on the positive side and the other end on
the negative side.
4. Tighten
the two screws.
~-- - -- - - - - - u - - - - - -- ~
i ~
SLIDING GUIDE (A)
41751
M2.6 x 6
f, Flat head
Screw x 4
I
~~ !•I~
~ M2.6 NUT x 2
1~-.I ----- ~' t+-----;t~I CONTA;;-73~0LDER
~
6-5
' I CONTACT SPRING
M2.6x 6 f
"'·Truss head
screw
41750
SPRING WASHER
I
I M2.6 x 6
~I 'r Round head
screw

Icom IC-H2 Specifications

General

Brand	Icom
Model	IC-H2
Category	Transceiver
Language	English