Icom IC-T90A User Manual

17
4
BASIC OPERATION
■ Turning power ON
D Turning power ON
q Make sure alkaline batteries are installed in the battery
case or the battery pack is charged, and attach them.
(p. 13)
w Push [PWR] for 1 sec. to turn the power ON.
• The function display shows “ICOM,” current voltage then the op-
erating frequency.
• Repeat this step to turn power OFF.
The opening message can be turned ON or OFF in the ex-
panded set mode 1. (p. 64)
DSetting volume level
The audio level can be adjusted through 32 levels.
➥ Push [Y] or [Z] to set the desired audio level.
• Rotating the tuning dial while pushing [Y] or [Z] also sets the
audio level.
• [Y]/[Z] and [DIAL] can be exchanged by [1 V↔D]. (p. 23)
DVolume level indication
The frequency display shows the volume level during setting
as shown below.
[
∫
]
[
√
]
Shows volume level.
[PWR]
FM SKIPP
Frequency indication
Opening message ‘ICOM’
Voltage indication
Indication Audio level
0 (no sound)
19–23 (default)
24–27
28–30
31 (Maximum)
1–11
12–18
IC-T90A_IM.qxd 02.6.6 08:44 AM Page 20 (1,1)

Icom IC-T90A Specifications

General

Brand	Icom
Model	IC-T90A
Category	Transceiver
Language	English