1.
2.
outer air duct.
3.
extension is required.
4.
from the ring near the terminal.
(Refer to Frames 19 and 23 for
detail of length measurement)
5. To ensure a square cut, mark the
6.
26
FITTING THE KIT
27
FITTING THE OPTIONAL FLUE FINISHING KIT AND OPTIONAL RS SEALING PLATE
Flue Finishing Kit
1. Fit black outer wall seal over terminal and ensure the retaining rim is
located in the terminal depression.
2.
3.
4. Fit outer wall sealing plate over outer wall seal and retain with the 4
screws and wall plugs provided.
Contents
Wall Seal White - 1 off
Wall Seal Black - 1 off
Wall Sealing Plate - 1 off
Screws No. 10x2” - 4 off
Wallplugs - 4 off
RS Sealing Plate
appliance, an optional extra terminal wall sealing
plate is available to make good the rectangular
Contents
Wall Seal plate - 1 off
Screws No. 10x2” Woodscrew - 4 off
Wallplugs - 4 off
To Next Page
Loading...
Need help?
General
