28
CONNECTING THE FLUE TO THE BOILER
1.
2.
with the marked line.
3.
(use label as a guide).
4.
1
/
8
”) dia drill.
5. Retain the connector with the 3 screws provided.
6. Adhere the 70mm wide x 20mm deep foam strip (found in the
inner seal to the hole cut in the wall.
7.
wall.
8. Remove the top outlet blanking plate or boiler top panel
adjacent cupboard to view the joint.
9.
screws provided.
10. Smear lubricant (to be found in hardware pack)
(B) engage to the lugs on the turret (A).
11. Replace the top outlet blanking plate.
12. Flues over 1 metre long.
the wall, using the wall plug
and wood screw.
To Next Page
Loading...
Need help?
General
