USING YOUR AUTOVAC ECLIPSE 8
Cleaning Modes
Auto Clean - The Eclipse will automatically clean your floor until it has covered the entire surface. Once it has cleaned the entire
surface it will automatically return back to the charging base.
Edge Clean - The Eclipse will find the edges of your room and focus on cleaning those edges throughout its cleaning cycle.
Spot Clean - The Eclipse will focus on a specific area and clean thoroughly. First, use the manual navigation buttons on the remote
control (or in the app) to guide the Eclipse to the desired area. Then, choose Spot Clean mode.
Single Room Cleaning - The Eclipse will focus specifically on cleaning one room by avoiding any open door ways.
Powermop - recommended after dry dust/debris is vacuumed manually or by your Autovac Eclipse. Attach the water tank as
described later in this manual. Choose Powermop in the iHome Clean App or the included remote and the Eclipse will automatically
mop the surface and return to the recharge base once complete. NOTE: During Powermop mode the Eclipse maintains a gentle
suction for dry debris into a separate compartment in the mop attachment.
Manual Control - Using the iHome Clean App or the included remote, you can manually control where the vacuum navigates.
To Next Page
Loading...
Need help?
General
