Storage and Shipment
Environment
This tester may be stored or shipped in environments with the following limits:
Temperature ...............................................................................-40° - 167° F (-40° - 75°C)
Altitude .................................................................................. 50,000 feet (15,240 meters)
The tester should also be protected against temperature extremes which may cause condensation within the tester.
Packaging
Contact our customer support department (1-847-932-3662) for an RMA (return materials authorization) number. Please enclose
the tester with all options, accessories, and test leads. Indicate the nature of the problem or type of service needed. Also, please
mark the container “FRAGILE” to insure proper handling. Please refer to the RMA number for all correspondence.
Packaging Instructions:
1. Be sure to REMOVE ALL ACCESSORIES and the INTERLOCK DISABLE from the tester.
2. Wrap the tester in a bubble pack or similar foam. Enclose the same information as above.
3. Use a strong double-wall container that is made for shipping instrumentation. 350 lb. test material is adequate.
4. Use a layer of shock-absorbing material 70 to 100 mm (3 to 4 inch) thick around all sides of the tester. Protect the
control panel with cardboard.
5. Seal the container securely.
6. Mark the container “FRAGILE” to insure proper handling.
7. Please ship models via Federal Express or UPS air.
8. Please refer in all correspondence to your RMA number.
hipot.com 38
To Next Page
Loading...
Need help?
General
