User Manual 3-6 V2.0
Application Kit TC3X7 ADAS V2.0 2018-06
Application Kit Manual TC3X7 ADAS
Hardware: Application Kit TC3X7 ADAS V2.0
Application Kit Information
The WAKE button (S102) will be used to enable/wakeup the TLF3068x.
3.17 Debug System
3.17.1 OCDS1
The OCDS1 signals are connected to the IDC16 plug (X401). They work with the port supply of Microcontroller (+5V
default or +3,3V). For pinout of the connector see Figure 6-8. You can connect any debugger to this connector.
The signals /BRKIN and /BRKOUT are not connected.
If you connect a debug hardware make sure that the miniWiggler JDS (see “miniWiggler JDS” on Page 3-4) is not
activ (ACTIV LED is off) and on the DAP connector (X302) is no hardware connected or the hardware is tristated.
If the ACTIV LED is on, then stop the active DAS Server ’UDAS’ and/or remove the USB connection to the PC.
3.17.2 DAP
The board comes with a DAP connector (X302). For pinout of this connector see Figure 6-9. You can connect a DAP
hardware here. If you use this connector make sure that the miniWiggler JDS is not activ (ACTIV LED is off) and a
connected OCDS1 hardware is disconnected or tristated.
To Next Page
Loading...
Need help?
General
