14 InFocus Corporation — Introduction Guide - DLP Multimedia Projector
Set up your InFocus
Turning the projector on / turning the projector off
Turning on your InFocus projector
1. Securely connect the power cord to the projector and to the mains outlet. When connected, the On/Standby
LED will turn red.
2. Connect your signal/source cable to you source device and the projector.
3. Turn on the projector by pressing the
either on the projector keypad or the remote control.
NOTE
The power cable that is supplied with this projector conforms to electrical safety regulations. Do not
use a power cable other than the one supplied with the projector. If using the projector overseas,
check the power supply voltage, outlet shape and electrical rating of the projector that conform to
the local standards, and purchase a proper power cable in the country.
RG2
Pantone 877C
Pantone 877C
RG 2
or
To Next Page
Loading...
Need help?
General
