To Next Page

To Previous Page

Unit Description

The Electronic Control System is composed of an Electronic

Control Module (located inside the condenser unit) and the

In-cab Control Box. This In-cab Control Box allows the truck

driver to operate the Thermo King refrigeration unit.

Electronic Control System

Description

The Electronic Control System has the following

characteristics:

• Auto Start

•Soft Start

• Active Display

• Lit Keypad

• Total Hourmeter

• Vehicle Compressor Hourmeter

• Electric Standby Compressor Hourmeter

• Low Battery Voltage Alarm

• Buzzer

• Unit Control without In-cab Control Box

• Manual or Automatic Defrost

• Maintenance Warning

• Return Air Temperature Sensor

• Setpoint Temperature Reading

• Electric Power Warning

Auto Start: Should the unit stop due to a failure in the power

supply, whether during on-the-road or electric standby

operation, it will start up again as soon as the power supply is

re-established.

Soft Start: All operation modes remain inactive for 15

seconds after an Auto Start.

Active Display: The In-cab Control Box display is always

active and backlit except when the unit is disconnected (no

power) or when the unit is connected but has been manually

switched off from the In-cab Control Box (when there is no

active alarm).

Lit Keypad: The In-cab Control Box keys are always lit

except when the unit is disconnected (no power) or when the

unit is connected but has been manually switched off from the