Unit Operation
38
Clearing Alarm Codes
The alarm condition in the unit must first be corrected. After
clearing the alarm condition, press and release the SELECT
key to remove existing ALARM codes. The standard display
will appear once the ALARM codes have been cleared.
Viewing Information Screens
Main Menu
From the Standard Display use the SELECT key to display:
1. Alarms (if any active)
2. Manual Defrost
3. Temperature Setpoint
Hourmeter Menu
From the Standard Display press the SELECT key for 3
seconds to open the Hourmeter Menu, then use the SELECT
key to display:
1. HC: Hours remaining to maintenance notice.
2. tH: The total amount of time the unit has been switched on
protecting the load.
3. CC: Engine-driven compressor operating hours.
4. EC: Electric standby compressor operating hours.
5. Return to Main Menu.
P1E Main or Single Cargo Box Return Air
Temperature Reading Error (open circuit or
short-circuit). Contact your Service Dealer.
P2E Remote Cargo Box Return Air Temperature
Reading Error (open circuit or short-circuit).
Contact your Service Dealer.
C Communications Failure. Contact your
Service Dealer.
Alarm Description
Unit Operation
38
Clearing Alarm Codes
The alarm condition in the unit must first be corrected. After
clearing the alarm condition, press and release the SELECT
key to remove existing ALARM codes. The standard display
will appear once the ALARM codes have been cleared.
Viewing Information Screens
Main Menu
From the Standard Display use the SELECT key to display:
1. Alarms (if any active)
2. Manual Defrost
3. Temperature Setpoint
Hourmeter Menu
From the Standard Display press the SELECT key for 3
seconds to open the Hourmeter Menu, then use the SELECT
key to display:
1. HC: Hours remaining to maintenance notice.
2. tH: The total amount of time the unit has been switched on
protecting the load.
3. CC: Engine-driven compressor operating hours.
4. EC: Electric standby compressor operating hours.
5. Return to Main Menu.
P1E Main or Single Cargo Box Return Air
Temperature Reading Error (open circuit or
short-circuit). Contact your Service Dealer.
P2E Remote Cargo Box Return Air Temperature
Reading Error (open circuit or short-circuit).
Contact your Service Dealer.
C Communications Failure. Contact your
Service Dealer.
Alarm Description