Installation Manual
10 General information
Level 4
ONLY authorized technicians, appointed by the Manufacturer can, by means of special tools, carry out
repair work on the motherboard (for example, repair or replace SM components).
2.6 Intellectual property rights
The information contained in this document is private property. All rights reserved.
No part of this document may be copied or reproduced unless expressly authorized in writing by INIM
Electronics, in particular the parts regarding the device specified in paragraph 2.14 Device identifier.
2.7 Disclaimer
INIM Electronics s.r.l. shall not be responsible for damage arising from improper application or use.
This control panel should be handled by qualified personnel only. Installation must be carried out
strictly in accordance with the instructions described in this manual, and in compliance with the local
fire code in force.
2.8 Recommendations
INIM Electronics recommends that the entire system be tested on a regular basis (refer to paragraph
2.9 Testing the system).
2.9 Testing the system
This system has been designed to the highest standards of quality and performance. The system may
fail to function as intended due to the failure of a component. Most problems that prevent a fire
control system from operating as intended can be found by regular testing and maintenance (refer to
Appendix A - Maintenance).
Testing should include all detectors, signaling devices and any other operational devices that are part
of the system.
2.10 Note to the installer
In order to provide adequate protection and instructions for proper use, you (the installer) must be
familiar with the operating procedure of this device. As the only individual in contact with system
users, it is your responsibility to instruct them on how to use this system properly and to bring to their
attention that every fire is different in the amount of smoke and rate of burning. Therefore, smoke
and heat detectors may not provide timely warning of fires caused by violent explosions, escaping gas
or improper storage of inflammable materials.
Regardless of its capabilities, a fire alarm system is not a substitute for the necessary precautions
building occupants must take to prevent or minimize the harmful effects of fire.
2.11 Technical support
Our professional engineers are readily available to assist you. Call our phone number and you will be
connected right away to a person who will answer all your questions and provide you with full
technical support.
2.12 Conventions
2.12.1 Glossary and terminology
Panel; device; system: refer to the devices defined in 2.14 Device identifier.
Left, right, behind, above, below: refer to the directions as seen by the operator in front of the
mounted device.
Communicator (telephone, SMS, digital): synonym of dialer.
STP: Shielded twisted pair cable.
Qualified personnel: those persons whose training, expertise and knowledge of the laws and bylaws
regarding service conditions and the prevention of accidents, are able to identify and avoid all possible
situations of danger.
To Next Page
Loading...
Need help?
General
