Installation Manual
8 Overview
The “/G” model is equipped with a keypad, display, fault LEDs and fast buttons and is suitable for
installation in locations where visual signals and manual control are necessary. This model can be
upgraded at any time after installation (for example, if moved to a location where extended visual
signals and manual control are necessary) by replacing its door with a “/P” model door that is
enhanced with a Zone status LED pad and thermal printer option.
The “/S” model has an unequipped door (no keypad, display or LEDs), and is suitable for installation
in locations where visual indications and manual control are not required (e.g. basements). This
model can be upgraded at any time after installation (for example, if moved to a location where visual
signals and manual control are necessary) by replacing its door with a /P model door or /G model door
(refer to respective paragraph for ‘on-door’ equipment details).
1.5 Features
- Manages up to 240 zones
- Network environment capable (maximum configuration 30 panels)
- Group and Zone sharing among panels in the network environment
- Switching power supply 27.6 V @ 4 A with battery charger function
- 2 on-board loops (on expandable 2080 models); 1 on-board loop (on non-expandable 1010
models)
- 3 programmable NAC outputs
- 1 NAC Alarm output
- 1 NAC Fault output
- 1 dry contact Alarm relay
- 1 dry contact Fault relay
- RS485 Bus — accommodates up to 8 SmartLetUSee Repeaters
- 1 power supply output @ 24 V for external devices.
- 1 power supply output @ 24 V for external devices with "power Cutoff" during reset.
- RS232 and USB connectors for uploading/downloading programming data
- 2000 event buffer
The motherboard provides locations for:
- 3 SmartLoop/2L loop expansion boards with 2 loops per board (for 2080 expandable models only)
- 1 SmartLoop/NET network board
- 1 SmartLAN board
- 1 SmartLoop/PSTN board
- 1 SmartLoop/INOUT Input/Output expansion board
- 1 SmartLoop/LED zone-status LED module (for “/P” models only)
- 1 SmartLoop/PRN thermal printer module (for “/P” models only)
Note: The 1010 non-expandable models with 1-loop have exactly the same features and components as
the 2080 expandable models with 2-loops.
To Next Page
Loading...
Need help?
General
