Inovance IS580 Series User Manual

IS580 User Manual Preface
- 1 -
Preface
Thank you for purchasing the IS580 series servo drive developed and manufactured by Inovance.
The IS580 is an upgrade product compared with the IS300 series servo drive. It is specially designed to drive the
permanent magnet synchronous motor (PMSM) and implement high-performance vector control of the PMSM. By
integrating the process control during driving of the injection molding machine (IMM), such as precise control of
injection speed and pressure holding, and stability control during cooperation with the IMM controller, the IS580 can
well control the servo pump and provide general-purpose servo functions. The IS580 is highly cost-effective and
reliable. It has obvious energy saving effect compared with traditional IMM control mode.
It is applicable to plastic molding, pipe extrusion, shoe making, rubber producing, and metal casting. Compared
with the IS300, the IS580 features better oil pressure control performance, faster pressure and speed response,
smaller steady pressure uctuation and smaller size.
This manual is a guideline for the selection, installation, parameter setting, on-site commissioning and
troubleshooting of the IS580 servo drive. It is only applicable to the IS580****-**-1 series servo drives.
Before using the servo drive, read this manual carefully to have a thorough understanding of the product. Keep the
manual well and forward it to end users with the product.
Note
•
The drawings in the manual are sometimes shown without covers or protective guards. Remember to
install the covers or protective guards as specied rst, and then perform operations in accordance with
the instructions.
•
The drawings in the manual are shown for description only and may not match the product you
purchased.
•
The instructions are subject to change, without notice, due to product upgrade, specication
modication as well as efforts to increase the accuracy and convenience of the manual.
•
Contact our agents or customer service center if you have any problem during the use.
Note
This user manual is only applicable to the IS580****-**-1 series servo drives.

Inovance IS580 Series Specifications

General

Brand	Inovance
Model	IS580 Series
Category	Servo Drives
Language	English