11
www.insigniaproducts.com
12-Cycle Electric and Gas Dryers
INSTALLATION INSTRUCTIONS
Choosing a location
• You should locate your dryer where there is enough space at the front for
loading the dryer and enough space behind for the exhaust system.
• Your dryer is factory-ready for the rear exhaust option. If you want to change
the vent location, see Changing the dryer vent location (optional)
on page 22
• Make sure that the room you install your dryer in has enough fresh air and that
there are no air-flow obstructions. The ambient temperature should not be
lower than 33° F (.6° C).
• For gas dryers, adequate clearance must be maintained as noted on the data
plate to ensure adequate air for combustion and the proper dryer operation.
WARNING
Fire Hazard
• Clothes dryer installation must be performed by a qualified installer.
• Install the clothes dryer according to the manufacturer’s instructions
and local codes.
• Do not install a clothes dryer with flexible plastic venting materials. If
flexible metal (foil type) duct is installed, it must be of a specific type
identified by the appliance manufacturer as suitable for use with
clothes dryer. Flexible venting materials are known to collapse, be easily
crushed, and trap lint. These conditions will obstruct the clothes dryer’s
airflow and increase the risk of fire.
• To reduce the risk of severe injury or death, follow all installation
instructions
• Save these instructions.
CAUTION
Important to installer
Read the following instructions carefully before installing the dryer.
These instructions should be kept for future reference.
• The dryer is not suitable for installation in a mobile home.
• Remove the door from all discarded appliances to avoid the danger of a
child being trapped and suffocating.
• The back of the dryer must be placed against a wall.
WARNING: Your dryer must be exhausted to the outside to reduce the risk of
fire when installed any place inside the house.
To Next Page
Loading...
Need help?
General
