25
www.insigniaproducts.com
12-Cycle Electric and Gas Dryers
INSTALLATION INSTRUCTIONS
6 Attach aluminum tape to the back of the dryer to seal the original dryer vent
hole.
Installing your dryer
Tools you will need
Materials you will need
• 3/8" gas dryer gas line (Gas model only)
• Three- or four-prong (dependent on owner’s house) electric power cord
(electric model only)
•Exhaust dryer vent kit
Before you start
Before you start installing your dryer, make sure that:
• The location you selected has a grounded electrical outlet. See Grounding
requirements on page 21.
• For U.S. models, you have the correct type power cord (not included). See
Electric requirements
on page 18.
Note: For Canadian models, the power cord comes pre-installed.
• Your dryer vent is in the correct location. See “Changing the dryer vent
location (optional)” on page 22 to change where your dryer vents.
• Your exhaust ducting (not included) is made of rigid metal or semi-rigid metal.
See Duct requirements
on page 17.
• You have a 3/8 in. (1 cm) gas dryer gas line (if you are installing a gas dryer)
that meets all national and local codes. Before you connect the gas line, review
the gas line requirements in Gas requirements
on page 20.
Important: We recommend that you use a qualified installer to install your
dryer.
Pliers
Phillips screwdriver
Level
Aluminum tape
Adjustable wrench that opens
to 1" (2.5 cm)
Cutting knife
Flat-head screwdriver
Pipe wrench
To Next Page
Loading...
Need help?
General
