72
Figure 20. Location of the Jumper Block
Table 38. BIOS Setup Configuration Jumper Settings
The BIOS uses current configuration information and passwords
for booting.
After the POST runs, Setup runs automatically. The maintenance
menu is displayed.
Note that this Configure mode is the only way to clear the
BIOS/CMOS settings. Press F9 (restore defaults) while in
Configure mode to restore the BIOS/CMOS settings to their
default values.
The BIOS attempts to recover the BIOS configuration. A
recovery CD or flash drive is required.
To Next Page
Loading...
Need help?
General
