Installations and Upgrades
55
Intel
®
SC5200 Base Server Chassis Note
Connect front system fans to the System Fan 3 and System Fan 5 connectors on the server board.
Intel SC5200 Hot-Swap, Redundant Power Server Chassis Note
Be sure to attach system fans to their correspondingly numbered connector on the server board.
System fan numbers can be found on the system fan carrier and on the system fan cables.
Installing the Serial B Cable
For the Intel SC5200 chassis, you can connect the Serial B serial port cable to either the front (rack
configuration only) or back panels. Connecting it to the back panel is illustrated below.
1. Install the Serial B cable by inserting it into the chassis back panel cutout and attaching it as
shown.
2. Attach the other end to the Serial B connector located on your server baseboard. See “Making
Connections to the Server Board” on page 38 for the Serial B connector location.
A
B
OM14557
A. Chassis Back Panel Cutout
B. Screw
Figure 29. Installing the Serial B Cable
To Next Page
Loading...
Need help?
General
